Auto cancelling turn signal delete

Presson · Post by **Presson** » Wed Jun 10, 2026 2:33 pm

Hey fellas, I realise this is an 8 gen specific question. Can anyone recall the procedure to delete the auto cancelling of the turn signals? I remember Grum posting some instructions and a diagram but can't find it in my hoard. It was very simple; a single wire cut I think.

The auto cancelling always seems to activate about halfway round a large roundabout which is extremely annoying and not something I want to be monitoring at that moment!

Skids · Post by **Skids** » Wed Jun 10, 2026 7:01 pm

I believe it's a feed off the abs circuit. On the CR, it was a yellow wire under the ftont RH plastics but it'll be different on the F.

Presson · Post by **Presson** » Wed Jun 10, 2026 7:48 pm

Thanks Skids, I'll have a pore over the wiring diagram.

Presson · Post by **Presson** » Fri Jun 12, 2026 3:46 pm

Thanks for the pointer Skids.

I can now confirm that to delete the turn indicators auto- cancel feature on the VFR800F you need to remove the lower and middle cowl on the right hand side. Access the turn signal/hazard relay connector (21P black illustrated in page 1-27 of the shop manual). Then cut or otherwise isolate the front wheel rotor signal wire which is the Pink/blue wire on pin 17.

Worfje · Post by **Worfje** » Sun Jun 14, 2026 7:47 am

Good to hear you were able to cancel the auto-cancel feature!